Математическая модель теплопередачи и массообмена при нейтрализации пороховых газов в боевом отделении бронетехники

Е.А. Мұсатай; М.И. Тулепов

doi:10.18321/cpc23(3)311-322

Authors

Y.A. Mussatay Al-Farabi Kazakh National University, al-Farabi ave., 71, Almaty, Kazakhstan
M.I. Tulepov Al-Farabi Kazakh National University, al-Farabi ave., 71, Almaty, Kazakhstan

DOI:

https://doi.org/10.18321/cpc23(3)311-322

Keywords:

armored vehicles, kinetics of decomposition, mass transfer, mathematical modeling, 4D is a four-dimensional mathematical model

Abstract

The article models the neutralization of powder gases in the fighting compartment using a pyrotechnic composition (sodium nitrate, powdered iron, activated carbon). Thermochemical pyrotechnic systems are characterized by a high reaction rate and intense gas and heat generation. Due to these properties, they are used in the reservation of machinery to create barriers that effectively separate powder gases and protect internal components from thermal and mechanical stress. The key factors of chemical neutralization efficiency are analyzed: the kinetics of oxidant decomposition, oxidation of the metal component, and thermal decomposition of carbon. A mathematical model of heat transfer, mass transfer, and chemical transformations in the interaction of gases with pyromass is proposed. Numerical analysis shows a significant decrease in concentrations of nitrogen and carbon oxides, which improves the sanitary and hygienic conditions of the crew. The developed algorithms are applicable to the design of air purification systems in armored vehicles and the creation of new pyrotechnic neutralizers.

References

(1) A.A. Almetwally, M. Bin-Jumah, A.A. Allam. Ambient air pollution and its influence on human health and welfare: An overview, Environ. Sci. Pollut. Res. 27 (2020) 24815–24830. Crossref

(2) Procedure for use in the protection of personnel, weapons, and equipment, Licensed advanced training courses for specialists (2010). URL

(3) P. Mock. ICCT’s comments and technical recommendations on future EURO 7/VII emission standards, Int. Counc. Clean Transp., Berlin (2021).

(4) F. Rodriguez, Y. Bernard, J. Dornoff, et al. Recommendations for post-Euro 6 standards for light-duty vehicles in the European Union, Int. Counc. Clean Transp. Europe, Berlin (2019). URL

(5) Ya.B. Zeldovich. On the theory of propellant and explosive combustion, Zh. Exp. Teor. Fiz. 12 (1942) 498–524 (in Russian). [Also in: Ya.B. Zeldovich, Selected works. Chemical physics and hydrodynamics, Nauka, Moscow, 1984, 374 p.].

(6) V.V. Zuev. Determination of the rate constant of aniline iodination: Methodological guidelines, ITMO Univ., St. Petersburg (2014) 50 p. (in Russian).

(7) G.N. Leonov. Burning surface temperature of nitrocellulose propellants as the determining factor of linear burning rate at high pressures, Electron. Phys.-Tech. J. 2 (2007) 55–62 p. (in Russian).

(8) M.Y. Nemtsev. Numerical modeling of the combustion processes of porous energy materials in a wide range of volume fraction, Diss. Cand. Phys.-Math. Sci., Moscow (2023) 26–30 p. (in Russian).

(9) I.S. Menshov, M.Y. Nemtsev, I.V. Semenov. Numerical modeling of wave processes accompanying combustion of inhomogeneously distributed composite propellant, Comput. Math. Math. Phys. 59 (2019) 1528–1541. Crossref

(10) M.I. Kiryushkina, E.P. Polyakov. Mathematical model of the combustion process of pyrotechnic fuel of porous structure with various methods of removal of gas-generation products from the combustion zone, Izv. TulSU. Tech. Sci. Ser. Thermogasodyn. Heat Mass Transfer 12 (2014) 1 p. (in Russian).

(11) B.G. Trusov. The TERRA software system for modeling phase and chemical equilibria in plasma-chemical systems, Vestn. Bauman MSTU 2 (2011) 1–4 p. (in Russian).

(12) P. Katara. Review paper on catalytic converter for automobile exhaust emission, Int. J. Innov. Res. Sci. Eng. Technol. 5 (2016) 9. Crossref

(13) S. Khurana, K.K. Rayat, S. Tadepalli, et al. Review paper on catalytic converter for automotive exhaust emission, Int. J. Inf. Comput. Sci. 5 (2018) 144–154. Crossref

(14) Abhinesh, Arun Kumar, D. Kumar. Minimization of engine emission by using non-noble metal based catalytic converter, Int. J. Curr. Res. 4 (2014) 2663–2468. Crossref